Air Top 2000 ST
3
Installation
IMPORTANT
The statutory regulations governing installation on pages 1 and 2 must
be adhered to. The requirements of the latest version of the ADR must
also be observed for the installing the heater into vehicles used to
transport hazardous substances.
The heater must not be operated without the control unit cover (this will
cause the heater to overheat).
1
6
1
Hot air inlet
2
Hot air outlet
3
Combustion air intake
4
Exhaust fume outlet
Fig. 1:
Dimensions of the heater
8
3 5 4
3.1.
Air Top 2000 ST installation situation
NOTE:
Check the installation situation of the relevant vehicle type.
3.2.
Installation location
The heater may be fitted both in the interior or on the exterior of the
vehicle.
If it is installed on the exterior ensure that the heater is fitted in a position
where it is protected from splashing water and spray.
2
5
Fuel intake
6
Space requirement for hot air inlet
7
Space requirement for removing the heater
8
Cable outlet (either right or left)
Installation
7
43