Reconnecting 7~8 - Blaupunkt Milan Range Instruction Manual

MILAN
Reconnecting
Before you begin
In the previous section you saw how to make that first connection between your Bluetooth device and the
MILAN . However, since most people don't leave their mobile phone at home all the time,or perhaps the
mobile phone is turned off from time to time, it will be necessary to reconnect your previously paired
Bluetooth device when you wish to stream music again. There are a few different ways in which reconnections
are made, and fortunately they are all very simple.
Searching mode
When the MILAN is in SEARCHING MODE (which is indicated by a fl ashing of the Blue LED), the
attempting to automatically connect to the most recently connected Bluetooth device. SEARCHING MODE
typically occurs when the
Bluetooth range section on Bluetooth wireless technology range. Once this most recent device is back within
range, the re-connection should be automatic. However, it may be necessary to initiate the audio playback on
the Bluetooth device. Note that the Searching mode will revert to Bluetooth Standby Mode (see next section)
if no re-connection is made.
Bluetooth Standby modeIf the most recently connected Bluetooth device can not be found during Searching
Mode, then the MILAN
accept connection from any previously paired Bluetooth devices (up to 8 devices). Simply initiate the
connection to the MILAN
Bluetooth rangeThe Bluetooth wireless technology generally can operate within a range of 33 feet or more.
However results may vary based on other factors such as your Bluetooth device performance, room layout,
wall material, weather conditions, etc. Also, note that when a mobile device goes out of range, the
will enter Searching mode and will attempt to automatically reconnect to the mobile device when that mobile
device comes back into range within 5 minutes. (See Searching Mode section for more information)
You can always enter Pairing mode by pressing and holding PAIR while in either SEARCHING MODE or
BLUETOOTH STANDBY MODE
If during SEARCHING MODE (Blue LED is flashing), you wish to quickly connect any other Bluetooth device
(including those previously paired), simply press/hold the PAIR button to enter PAIRING mode, and
proceed to PAIR the Bluetooth device (see PAIRING section).
Generally when the user disables the Bluetooth wireless connection on a connected Bluetooth device the
MILAN will enter Bluetooth Standby mode which means that the
previously paired Bluetooth devices to connect (See Bluetooth Standby Mode section for more information).
However, in some cases, the disabling of Bluetooth wireless connection on the connected Bluetooth
device may not result in the
Searching Mode. (See Searching Mode section for more information)
MILAN is fi rst turned on, or if the Bluetooth device goes out of the range. See the
will revert to BLUETOOTH STANDBY MODE. While in this mode, the
on your Bluetooth device. See your Bluetooth device for more information.
MILAN immediately entering Bluetooth Standby mode, and may enter
MILAN
7
MILAN
MILAN
would be available for other
is
will
MILAN