Engine Coolant - Sea-doo Spark Series Operator's Manual

In or Out of Water
5. To check level, remove access
cover located on rear of RH side of
watercraft by turning counterclock-
wise.
smo2014-005-024_a
TYPICAL
1. RH access cover
6. Unscrew dipstick, pull it out and
wipe clean.
NOTE: Inner side of RH access cover
is equipped with an extension to facili-
tate dipstick unscrewing.
smo2014-005-025_a
1. RH access cover - extension side
2. Dipstick
7. Reinstall dipstick, push in com-
pletely.
8. Remove dipstick again and read
oil level. It should be between the
MAX and MIN marks.
smo2014-005-027_a
1. Maximum
2. Minimum
3. Operating range
9. Add oil to ensure the level is be-
tween marks as required.
NOTE: Do not overfill.
To add oil:
– Place a funnel in the oil neck open-
ing.
– Add the recommended oil to the
proper level.
NOTE: Every time oil is added in the
engine, the complete procedure ex-
plained in this section must be carried
out again. Otherwise, you will obtain a
false oil level reading.
10. Properly reinstall dipstick and RH
access cover.
Engine Oil Change and Oil Filter
Replacement
The oil change and filter replacement
should be performed by an authorized
Sea-Doo dealer.

Engine Coolant

Recommended Engine Coolant
Always use LONG LIFE ANTIFREEZE
(P/N 219 702 685). If the recom-
mended coolant is not available, use a
low silicate, extended life ethylene-gly-
col premixed coolant (50%-50%)
specifically formulated for internal
combustion aluminum engines.
To prevent antifreeze deterioration, al-
ways use the same brand and grade.
Never mix different brands or grades
unless cooling system is completely
flushed and refilled. Refer to an autho-
rized Sea-Doo dealer.
_______________
MAINTENANCE PROCEDURES
81