Deck Housing; Clutch Cable Adjustment - Hayter Harrier 48 490E Owner's Handbook Manual

MOWER MAINTENANCE

Deck Housing

Securing Nuts & Bolts
1CG480V36B

Clutch Cable Adjustment

Fig. 1
1
2
Fig. 2
10-20mm
1.26
Remove grass debris from the top and underside of the deck housing
immediately after use.
Fertilisers and top dressings are particularly corrosive.
Thoroughly clean the mower deck immediately after use on treat-
ed grass and store well away from corrosive materials.
Regularly check that all securing nuts and bolts are tight. Replace
missing or damaged items immediately.
First slowly pull the mower backwards whilst doing this, gently start
to move the clutch lever towards the handlebar by 10 - 20mm. If no
resistance can be felt, carry out the following steps:
1. Unscrew the lock nut (1) Ref Fig 1
2. Undo adjusting screw away from control. (2) Ref Fig 1
3. Pull the mower backwards and keep adjusting the adjuster
screw (2) until resistance can just be felt when moving the
clutch lever forward 10 - 20mm. Ref Fig (1)
4. Screw in the adjuster screw by 1 turn. Ref. Fig (1)
5. Tighten locknut (1). Ref Fig (1)
6. Pull back the mower and make sure the mower moves freely
with the clutch disengaged.
7. Slowly pull the mower backwards while gently starting to
push forward on the clutch lever.
Ref. Fig (2). Resistance should now be felt when the lever
has moved 10 - 20mm towards the handlebar. This is now
correctly adjusted.