install the convex (rounded outward) side of the Grinding Wheel toward the
Spindle (7). (See Figure E.)
3.
Screw the Outer Flange Nut (1) onto the Spindle (7). Depress and hold the Lock
Pin (22) to keep the Spindle from turning. Then, use the provided Wrench (51)
to firmly tighten the Outer Flange Nut onto the Spindle. (See Figure E.)
A
GRINDING
WHEEL
SPINDLE
(7)
OUTER
FLANGE
NUT
(1)
To Attach The Side Handle:
The Side Handle (18) may be attached to either the left or right side of the Angle
1.
Grinder. (See Figure F.)
2.
To attach the Side Handle (18) to the Angle Grinder, screw the Handle firmly into
the threaded mounting hole located on either the left or right side of the Shell
Head (23). (See Figure F.)
FIGURE F
1.
WARNING! Make sure the Power Switch (41) of the Angle Grinder is in its
"OFF" position before connecting the Power Cord/Plug (50) to a 120 volt,
grounded, electrical outlet.
SKU 95578
For technical questions, please call 1-800-444-3353
B
OUTER
FLANGE
NUT
(1)
FIGURE E
SIDE
HANDLE
(18)
OPERATING INSTRUCTIONS
WRENCH
(51)
SHELL
HEAD
(23)
C
LOCK PIN
(22)
PAGE 11