2006 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions, please call 1-800-444-3353.
Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks SKU 94855 PRODUCT SPECIFICATIONS Description 18 VDC Battery, 1.3 Ah.
Do not use a power tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. SKU 94855 ELECTRICAL SAFETY eliminates the need for the three wire grounded...
Page 4
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with a sharp cutting edge are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools “Do not use” until repaired. SKU 94855 TOOL USE AND CARE PAGE 4...
Maintain labels and nameplates on the Impact Wrench. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement. When using the Impact Wrench, always maintain a firm grip on the tool with both hands.
Page 6
WARNING: This product contains or, when used, produces a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. (California Health & Safety Code 25249.5, et seq.) SKU 94855 PAGE 6...
Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.) FIGURE A SKU 94855 GROUNDING WARNING! PAGE 7...
(See Figure C.) If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Figure C.) SKU 94855 EXTENSION CORDS PAGE 8...
Page 9
5.1 – 7.0 7.1 – 12.0 12.1 – 16.0 16.1 – 20.0 FIGURE C to five volts at 150% of the rated amperes. SKU 94855 (120 VOLT) EXTENSION CORD LENGTH Feet Feet * Based on limiting the line voltage drop...
When unpacking, check to make sure all the parts shown on the Parts List on page 14 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Page 11
Once the Battery (30) is fully charged, disconnect the Charger (48) from the electrical outlet. Next disconnect the Charger Base (50) from the Battery (30). Press in the tabs on the Battery (30) while sliding out the Charger Base (50) (see Figure 1, on the next page). SKU 94855 PAGE 11...
Page 12
Impact Wrench. The more you depress the Trigger Switch (21) the faster the Impact Wrench will turn. When finished, release the Trigger Switch (21) to stop the Impact Wrench. Then, remove the Battery (30) and Socket (49) from the tool. SKU 94855 GREEN POWER INDICATOR Tabs...
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 94855 PAGE 13...
32 34 18 20 9 49: 1/2” SOCKET (not included) NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 94855 ASSEMBLY DIAGRAM PAGE 15 REV 12/06...