Audiovox AA-9005 Owner's Manual & Installation Manual page 9

MOUNTING COMPONENTS (CONT.)
MOUNTING THE SENSOR/CONTROL MODULE
The SensortControl Module (1)' is mounted in the vehicle's
passenger compartment
It
can
be
mounted by means of a snap-on
visor dip to the passenger side sun-visor or alternatively the module
may be mounted directly to the canter console or lower dash by means
of self-adhering Velcro® pads (9) supp6ed in the kit. It is not
recommended to mount this module on top of the dash. in direct
sunlight as high temperatures may damage the unit. Refer to GeneraJ
Specifications section.
SUN-VISOR MOUNTING METHOD
1. Attach the visor mounting dip (2) to the Sensa r/Control Module (1)
by snapping the tabs on the clip into the grooves on the sides of the
SensorlControl Module (1) as shown in figure (5). Be sure to
position the clip on the flat. battery compartment side of the module
(1) with the visor dip opening facing toward the front (narrow end)
of the module.
2. Once it is attached to the Sensor/Control Module (1) sfide the open
end of the visor clip (2) onto the passenger's side sun-visor. over
the edge of the visor closest to the windshield.Choose a visor
location where you have the ability to see all three status indicator
LE.D. fights and where you easily have accass to the ON/OFF
keys witch area
Page 8
Figure
5