Table of Contents
Advertisement
CONSOLE OR UNPER-DASH MOUNTING MEJtIOD
1. Locate the 2.5-
x
2.5- Velcro® pads (9) supplied with the kit.
2.
Stick the pads together keeping
all
the edges lined up
as
closely
as possible.
3. Remove the protective paper from the adhesive on one side of the
Velcro® "sandwich-.
4. Position and stick the Velcro® pads over the center of the
flat
(battery compartment) side on the Sensor/Control Module (1). See
figure,(6)
CAUTION: 00 not stick the pads onto or over the battery
compartment doo.( or over the small white labels with your
transmitter code numbers on them.
5.
Choose a location on the console or under your dashboard where
you have the
ability
to see all three status indicator
LED.
lights
and where you easily have accass to the ON/OFF keyswitch area.
6.
Remove the protective paper from the remaining side
of
the
Velcro®pad "sandwich- still attached to the Sensor/Control Module
(1), and stick the module to the chosen dash location.
NOTE: Be sura that the mountIng area Is clean
and
dry to
Insure proper adhesion.
Page 9
~
~
.. . .
.
..
.
.
.
,
Rgure 6
Advertisement
Table of Contents
