Table of Contents
Advertisement
SYSTEM SET-UP AND ADJUSTMENTS
TuRNING THE SYSTEM ON
Before we can discuss the operation and adjustments of the
M-
;J005 the Siren Module and the Sensor/Control Module must ba turned
In.
fumIng On The SIren Module
1. locate the protective rubber switch cover on the back of the Siren
Module (4).
2. Remove the cover (but do not discard) to expose the Siren Module
power switch.
3. Sfide the switch
to
the ON position and then re-insert the rubber
plug to prevent water retention. See figure (7)
4~
Assuming you have made the proper connections to the vehicle's
battery as described under.':Component Wiring" the Siren Module
should now be energized.
'umlng On The Sensor/Control Module
1. locate one of the small tubular Control Module ON/oFF keys (9).
2. Insert the key into the security key-switch located on the
Sensorl
Control Module (1) and turn to the ON position. See figure (10)
3. Find one of the Remote keychain transmitters (8) and keep it
handy.
l. Assuming the Siren Module is energized you should hear one
-chirp· from the siren indicating that the system has baen
armed.
You will also notica that the green LE.D. on the front ofthe Sensor/
Control Module will steadily illuminate. indicating that the module
is energized. The red LE.D. will also start flashing when the key
switch
is
first turned on, indicating that the alarm is armed.
".<
<
.
5. Before continuing any further. the alarm system must be disarmed.
6. FlOd the remote keychain transmitter and depress the button.
7. The siren should -chirp-two times and the red LE.D. inoJCator on
the Sensor/Control Module should turn off indicating that the
system is now disarmed.
ArmIng And DIsarm Ina
Test
With The Kevchaln Transmftters
You should now check the operation of each of the keychain
transmitters as follows:
1.
Exit
the vehicle making sure to close
an
doors, trunk and hood.
2. Test one keychain transmitter at a time. Depress the transmitter
button momentarily and you should hear the siren ·chirp" onca
indicating the system is armed. Press the button once again and
you should hear multiple chip indicating the system is disarmed.
3. To test the ·Panic· feature. hold the transmitter button down for
approximately 3 seconds and the siren should start to sound
continuously. Depress the transmitter button again. The siren will
stop sounding and you will hear multiple chirp indicating that the
alarm is again disarmed.
4. Repeat steps 2 and 3 to test the operation of the second keychain
transmitter.
Page 12
Advertisement
Table of Contents
