Table of Contents
Advertisement
~nS9r
Control Module Battery Replacement
Your Sensor/Control Module (1) has a built-in. replaceable 9 volt
battery. This battery allows the system to remain operational even if the
power is removed from the Sensor/Control Module
by
unplugging its
external power source.
NOTE:
Cara must be taken to tum
"OFF"
tha Sensor/Control
Module with the tubular
security
key (8) Ifthe module Is unplugged
from the vehlcla's maIn power source or removed for storage.lf-
thIs Is not dona the back-up 9 volt batteryw/ll draIn quickly!
To replace the transmitter's battery proceed as follows:
1. Shut off the Sensor/Control Module (1)
by
inserting a tubular
security ket (8) into the security key-switch located on the "wedge"
side of the Module. a"nd tum to the OFF position.
2.
Unplug the power lead from the SensortControl Module and
remove the module from its mounted position.
3. Locate the battery compartment cover on the "flat" side of the
Sensor/Control Module (1) as shown in flQure (12).
4. Slide the battery compartment cover off the module and remove
the bacl<-up battery.
5. Replace t.he old battery with a new alkaline 9-volt battery.
6. Return the bacl<-up battery into
its
compartment and replace the
battery compartment door.
7. Ra-mount the Sensor/Control Module to its original pashion, ra-
conn ect the power plug. and turn the security key-switch to the ON
position.
Page 17
"
y
9 Volt Alkaline Battery
Orange Wire Loop Ins
Figure 12
Advertisement
Table of Contents
