Audiovox AVT597 Owner's Manual
Audiovox AVT597 Owner's Manual

Audiovox AVT597 Owner's Manual

Audiovox 4 button remote security system with dual stage shock sensor owner's manual aps-597

Advertisement

4 Button Remote Security System
with Dual Stage Shock Sensor
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due
to battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such
situations. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Valet Switch manual override is pre-selected from the factory, however, the system
can be configured for "Custom Code" operation. Confirm the override mode selected on the
last page of this manual, and familiarize yourself with the selection on it's operation.
FEATURES :
w 1 Five Button Programmable RF Transmitters
w 1 Five Button Programmable Transceiver
w Five Channel Receiver (Capable Of Accepting Up To 4 Transmitters)
w Code Hopping Technology
w Selectable Manual Override Mode
w Remote Panic in all modes
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED (Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w Additional Engine Immobilizer Output (optional relay required)
w True Last Door Arming (hardwire only)
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter
w 6 Tone Multi Tone Siren
w RF Inhibit with ignition on
w Parking Light Flasher
w Plug In Dual Stage Shock Sensor
OPTIONS:
w Remote Trunk Release ( must have electronic trunk release )
w Remote Keyless Entry ( must have power door locks )
w Multiple Vehicle Capable
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Two Step Unlock Configurable
w Headlight Illumination During Arming, Disarming, Or Both
Model APS-597
Owner's Manual
Page 1
128-7406
1 of 16

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox AVT597

  • Page 1 4 Button Remote Security System with Dual Stage Shock Sensor IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this system is equipped with selectable manual override circuitry. It is possible that you will need to manually override your security system if the transmitter becomes lost, or inoperative due to battery failure.
  • Page 2 YOUR “ Code Hopping “ TRANSMITTERS The transmitters included with your new security system use the most ad- vanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and retransmit at a later time to disarm your system.
  • Page 3 (d) You can select Icon Mode or Text mode (e) You can select Language of text from English, Spanish or French (f) Set the temperature readout to display in "Fahrenheit or Celsius (Available on certain model remote start units) (g) Set the melody for the Alarm Clock (h) You can set the unit to provide a Tone, or Vibrate upon activation (i) You can set the Countdown Timer (j) You can set the Alarm Clock...
  • Page 4 Power Save Feature. Press the "F" and Lock buttons simultaneously to toggle this feature on and off. With this mode on, the battery in the transmitter will go into a power down mode when the unit is disarmed. 24 Hour start Timer. This icon is displayed when the 24 hour start timer is activated.
  • Page 5: Arming The System - Active

    option is installed, the vehicle's trunk will open. The two way transmitter, if within range, will display the trunk opened in text or by the icon as shown. ARMING THE SYSTEM - ACTIVE 1. Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid. 2.
  • Page 6: Protection While The System Is Armed

    þ Parking Lights flash one time. þ Siren sounds one chirp If the siren did not sound when arming, then the chirps have been turned off, and you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS" in this manual. o Doors Lock - Optional Door locking during passive arming is a selectable feature.
  • Page 7: While The System Is Sounding

    flashing rapidly, indicating that the system is re-arming automatically. Open any door to suspend the automatic arming. þ Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered.
  • Page 8: Intrusion Warning Signals

    disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly useful if you are aware of children play- ing near your vehicle that may accidently trigger your security system. In this case you can cancel the siren sounding without disarming your alarm.
  • Page 9: Programming Your Custom Code Override

    Switch manual override as indicated on the last page of this manual, to by-pass the alarm system. 1. Open the vehicle door. The alarm will sound. 2. Turn the ignition key to the on position. 3. Within 5 seconds, press and release the valet push button switch. The alarm system will stop sounding and enter the disarmed mode.
  • Page 10: Eliminating The Normal Arm / Disarm Chirps

    2. Turn the ignition switch to the on position. 3. Within 10 seconds, press and release the valet/override switch, 3 times. 4. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5.
  • Page 11: Remote Panic Operation

    If the chirps were off before you started, then you will hear one chirp indicating they have been turned on. NOTE: Whenever the chirps are by-passed, the 4 chirp intrusion indicator and 3 chirp defective zone indicator will always operate. Since these are important warnings to you that something has happened, they cannot be eliminated.
  • Page 12: Telematic Upgrade

    o Remote Window Closure o Remote Garage Door Interface To activate the optional accessory, press the programmed button on the keychain transmitter for up to 8 seconds for continuous output, or press and release for momentary activation. The optional accessory will immediately engage. Check with your installation center for more information on the optional accessory that may have been installed and how it is accessed.
  • Page 13 THIS PAGE LEFT BLANK INTENTIONALLY Page 13 128-7406 13 of 16...
  • Page 14 SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING SLOW FLASHING = ON SOLID 3 FLASH...PAUSE = 2 FLASH...PAUSE = 1 FLASH...PAUSE = SIREN CHIRP INDICATORS *1 CHIRP *2 CHIRPS 3 CHIRPS 4 CHIRPS * These chirps are optional, and can be de - activated. PARKING LAMP INDICATORS 1 FLASH 2 FLASHES...
  • Page 15 THIS PAGE LEFT BLANK INTENTIONALLY Page 15 128-7406 15 of 16...
  • Page 16 © 2005 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-7406 Page 16 128-7406 16 of 16...

Table of Contents