Table of Contents
Advertisement
4 Button Remote Security System
with Dual Stage Shock Sensor
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due
to battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such
situations. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected.
Valet Switch manual override is pre-selected from the factory, however, the system
can be configured for "Custom Code" operation. Confirm the override mode selected on the
last page of this manual, and familiarize yourself with the selection on it's operation.
FEATURES :
! 1 Four Button Programmable RF Transmitters
! 1 Five Button Programmable Transceiver
! Five Channel Receiver (Capable Of Accepting Up To 4 Transmitters)
! Code Hopping Technology
! Selectable Manual Override Mode
! Remote Panic in all modes
! Protected Valet
! User Programmable Manual Override Code
! 7 Function LED (Light Emitting Diode) - Arm / Disarm / Zone 1, 2, 3 / Valet / Arming
! Intrusion Alert with Memory
! Audible Arm / Disarm / Defective Zone / Tamper Confirmation
! Instant Siren Activation
! Starter Disable
! Additional Engine Immobilizer Output (optional relay required)
! True Last Door Arming (hardwire only)
! Defective Zone By-Pass
! Hardwire or Voltage Sense Selectable
! Active or Passive Arming Selectable
! Programmable Auto Lock On / Off
! Programmable Auto Unlock On / Off
! Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
! Programmable Active or Passive Door Locks
! User Programmable Permanent Chirp Delete
! On Command RF Chirp Delete from Transmitter
! 6 Tone Multi Tone Siren
! RF Inhibit with ignition on
! Parking Light Flasher
! Plug In Dual Stage Shock Sensor
OPTIONS:
! Remote Trunk Release ( must have electronic trunk release )
! Remote Keyless Entry ( must have power door locks )
! Multiple Vehicle Capable
! Remote Starter
! Remote Power Window Roll Up
! Remote Garage Door Interface
! Two Step Unlock Configurable
! Headlight Illumination During Arming, Disarming, Or Both
Model APS-596
Owner's Manual
128-7131
1 of 16
Advertisement
Table of Contents
Related Manuals for Audiovox Prestige Platinum APS-596
Summary of Contents for Audiovox Prestige Platinum APS-596
- Page 1 ! Remote Trunk Release ( must have electronic trunk release ) ! Remote Keyless Entry ( must have power door locks ) ! Multiple Vehicle Capable ! Remote Starter ! Remote Power Window Roll Up ! Remote Garage Door Interface...
-
Page 2: Arming The System - Active
YOUR “ Code Hopping “ TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and retransmit at a later time to disarm your system. -
Page 3: Arming The System - Passive ( Automatic )
entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correc- tion. # Doors Lock - Optional # Headlight Illumination - Optional ARMING THE SYSTEM - PASSIVE ( AUTOMATIC ) 1. -
Page 4: Disarming The System
DISARMING THE SYSTEM As you approach the vehicle, press and release the Unlock button on the keychain Transmitter. " Dash mounted LED turns off. If passive arming was selected during the installation, then the LED will start flashing rapidly, indicating that the system is re-arming auto- matically. -
Page 5: While The System Is Sounding
transmitter has a separate lock/unlock buttons, pressing the unlock button anytime after the first unlock command will cause all the vehicle doors to unlock. # Headlight Illumination - Optional WHILE THE SYSTEM IS SOUNDING If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. - Page 6 MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH MANUAL OVERRIDE Your Security System can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. If your system has been selected for Valet Switch manual override as indicated on the last page of this manual, to bypass the alarm system.
-
Page 7: Eliminating The Normal Arm / Disarm Chirps
Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to “52” you would do the following: 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. 2. Turn the ignition switch to the on position. 3. -
Page 8: Remote Panic Operation
can be turned off permanently, eliminating the need to hold the ARM / DISARM button for two seconds. To do this, 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release the valet push button switch three times. -
Page 9: Telematic Upgrade
ADDITIONAL REMOTE FUNCTION ( CHANNEL 4 ) This security system has an additional feature that can be connected to a number of different optional accessories. Some of the more common uses for this channel are: # Remote Trunk Release # Remote Window Closure To activate the optional accessory, press the programmed button on the keychain transmitter for up to 8 seconds for continuous output, or press and release for momentary activation. - Page 10 Included with your system is a two way remote transceiver that makes use of a LCD screen to indicate certain that the vehicle reacted to commands that you executed from the hand held transmitter(s). Shown below are these screens for reference. When Disarmed, Press the Arm/Lock button to Lock and Arm the System.
- Page 11 If the alarm system has been triggered, the icon displayed on the transmitter LCD will in- dicate which zone has been activated, as well sound the beep tones, or vibrate dependent upon the setting as shown above. The fol- lowing trigger patterns will be displayed. Triggered and the entry attempt was made to one of the vehicle doors.
- Page 12 The Battery Icon Indicator will show 3 bars as shown left, when the battery is at full capacity and will show less than 3 bars as the battery deteriorates. This is a guide and should be used to monitor the condition of the battery.
- Page 13 Parking Meter Counter: The transmitter has a built in clock that can count down from 10, 20, 30, 60, 90, or 120 minutes. This feature is useful when parking the vehicle in a metered parking lot. If the time on the parking meter is 30 minutes, you can set the count down timer to 20 minutes.
- Page 14 128-7131 14 of 16...
- Page 15 SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING SLOW FLASHING = ON SOLID 3 FLASH...PAUSE = 2 FLASH...PAUSE = 1 FLASH...PAUSE = SIREN CHIRP INDICATORS *1 CHIRP *2 CHIRPS 3 CHIRPS 4 CHIRPS * These chirps are optional, and can be de - activated. PARKING LAMP INDICATORS 1 FLASH 2 FLASHES...
- Page 16 © 2004 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-7131 128-7131 16 of 16...