center for programming details. The system comes from the factory with a
pre-programmed override code of 11.To change this default override code, do
the following:
1.
Disarm the system by use of the transmitter, or by use of the emergency
override sequence. Turn the ignition switch to the ON position.
2.
Within 10 seconds, press and release the valet/override switch, 3 times.
3.
Within 10 seconds turn the ignition switch OFF, ON, OFF, ON, OFF, ON.
(The siren or horn will beep and the lights will flash one time.)
4.
Within 10 seconds, begin to enter your chosen 10ths digit by pressing
and releasing the pushbutton switch from 1up to 9 times.
5.
Within 10 seconds of the last entered 10ths digit, turn the ignition switch
OFF then ON.
6.
Within 10 seconds, begin to enter your chosen units digit by pressing and
releasing the pushbutton switch from 1 up to 9 times.
7.
Finish by turning the ignition switch to the OFF position.
If the new code was accepted, the system will report back the newly entered
code, by flashing the LED, first indicating the 10ths digit, pause and then the
units digit. The system will report the new code three times with a one second
pause between each code, then the system will begin arming. If the LED flash
pattern reports the previously stored code, the new code was not entered
correctly. Please repeat steps 1 through 7 above considering the following.
NOTE: Acceptable digits 10ths or units are 1 through 9. The system will not
recognize a 0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for
more then 5 seconds during any of the above steps, the system will revert
back to the last successfully stored code.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE CUSTOM CODE OVERRIDE:
Assuming the override code programmed has not been changed, and the
default override code of 11 is in the system's memory.
1.
Enter the vehicle and turn the ignition switch to the ON position.
NOTE: The siren will sound.
Page 7
128-6530
7 of 10
Need help?
Do you have a question about the CA 610 and is the answer not in the manual?
Questions and answers