Valet Switch - Code Alarm CA 610 Owner's Manual

VALET SWITCH:

The valet switch allows you to temporarily bypass all alarm functions,
eliminating the need to hand your transmitter to parking attendants or garage
mechanics. When the system is in valet mode, all alarm functions are
bypassed, however the remote panic feature and remote door locks will
remain operational.
1. Enter the vehicle, and turn the ignition key to the ON position.
2. Press and hold the valet pushbutton switch until the dash mounted LED
turns on solid. The system will remain in the valet mode.
3. To return to normal operation, press and release the pushbutton switch
any time the ignition is on.
NOTE: Always remember to return the vehicle to the valet OFF position. This
will ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE VALET SWITCH MANUAL OVERRIDE
Your Security system can be disarmed without the use of the keychain
transmitter. This is necessary, since you will need the ability to operate your
vehicle if the transmitter is lost or its battery fails. If your system has been
selected for Valet Switch manual override as indicated on the last page of this
manual, to by-pass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the ON position.
3. Within 5 seconds, press and release the valet pushbutton switch.
The alarm system will stop sounding and enter the (by-passed) mode. You
can now start and operate the vehicle normally.
Typically this override mode is used only if the transmitter has become
inoperative.
Programming Your Custom Override Code:
Unlike override switches easily found, and defeated, this security system
allows the consumer to program a personal override code, offering a higher
level of security. To take advantage of this option, programmable feature # 10
must be selected for the Custom Code Option. Consult your installation
Page 6
128-6530
6 of 10