Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Code Alarm CA100
Summary of Contents for Code Alarm CA100
- Page 1 CA 100 Owners Manual 128-6530 1 of 10...
-
Page 2: Arming The System
Your System has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. -
Page 3: Protection While The System Is Armed
PROTECTION WHILE THE SYSTEM IS ARMED: Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger immediately. The siren will sound and the parking lights will flash for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left the door opened, the system will sound for six 30 second cycles then shut down, isolate the triggered zone and continue to protect all other zones. -
Page 4: Valet Switch
INTRUSION WARNING SIGNAL: This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern. -
Page 5: Eliminating The Normal Arm/Disarm Chirps
MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH/ MANUAL OVERRIDE Your system can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. To by-pass the alarm system; 1. - Page 6 the panic feature will continue for the allotted 30 seconds, however, the security system will be disarmed allowing the vehicle to start. ADDITIONAL REMOTE FUNCTION CHANNEL 3 The system has an optional feature, (Channel 3), that can be connected to the Trunk Release.
- Page 7 switch one time will reset the anti hi-jack mode. Page 7 128-6530 7 of 10...
- Page 8 SYSTEM FUNCTIONS AT A GLANCE ALARM DASH LED INDICATORS RAPID FLASHING SLOW FLASHING ON SOLID 5 FLASH...PAUSE 4 FLASH...PAUSE 3 FLASH...PAUSE 2 FLASH...PAUSE ALARM SIREN CHIRP INDICATION 1 CHIRP* 2 CHIRPS* 3 CHIRPS 4 CHIRPS ALARM PARKING LAMP INDICATIONS 1 FLASH 2 FLASH 3 FLASH ©...
- Page 9 Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts directly related to repairs of the defect(s).
- Page 10 128-6530 10 of 10...
Need help?
Do you have a question about the CA100 and is the answer not in the manual?
Questions and answers