Finishing; Operating Instructions; Finishing Checklist; Operating By Remote Control - Desa CGEF26 Safety Information And Installation Manual

FINISHING

Combustible Finishing Material: Materials
made of or surfaced with wood, compressed paper,
plant fibers, plastics or any material capable of
igniting and burning, whether flame proofed or not,
plastered or unplastered (this includes drywall).
Noncombustible Finishing Material : Mate-
rials which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick,
tile, concrete, slate, glass or plasters or combina-
tions thereof or have a fire rating of zero.
WARNING: Grills on this heater
cannot, in any way, be covered as
it may create a fire hazard,

FINISHING CHECKLIST

• Power supply service must be completed prior
to finishing to avoid reconstruction.
• Grilles and air openings cannot be covered in
any circumstances.
Note: The heater is a zero clearance fireplace and
may be finished with combustible or noncombus-
tible finishing materials.
When using paint or lacquer to finish the mantel, they
must be heat resistant to prevent discoloration.
OPERATING
INSTRUCTIONS
The controls (see Figure 5) are located behind
the bottom panel. Pull gently on bottom panel
to open.
Power LED
Figure 5 - Controls For Electric Fireplace
116686-01A
ON/OFF
Power Button
FL
www.desatech.com
1. Plug in your electric fireplace.
2. Main ON/OFF Power Switch and LED:
This switch is located on the right side of
the control panel. The power LED will
light up when the unit is on (see Figure 5).
When unit is on, the default settings for the
fireplace is low background lighting and
high ember bed and flame and the heater
is off.
3. Temperature Control Button and LED:
This button is located to the left of the Re-
mote Control Receiver (see Figure 5). The
LED is located to the left of the Flame But-
ton. Push button to cycle through settings.
When this button is pushed the LED will
change to its corresponding color: Green
for LO, Orange for MED and Red for HI.
When heater is on heat will emit through
vents located in the middle of the top louver
panel (see Figure 4).
The heater has a built-in thermostat so
it will shut off automatically once the set
temperature is reached. It will also turn
on automatically if the room temperature
drops below the set temperature.
Note: When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
4. Flame Control Button: This button is lo-
cated to the left of the Temperature Button
(see Figure 5). After power is on, push the
Flame Control Button to adjust flame and
ember bed brightness. Press and release the
Flame Control Button to cycle through LO,
MED, HI and OFF.

OPERATING BY REMOTE CONTROL

1. Plug in your electric fireplace.
2. Push the ON/OFF Power Button to turn
unit on. Power LED will light.
3. When operating the remote control, it must
be pointed at the sensor on the bottom
panel. Note: Make sure your batteries are
fully charged and installed correctly in your
remote control.
4. The ON/OFF button at the top left of the
remote is the main ON/OFF power button.
Pressing this button activates the power to
the unit.
5. To adjust the ember bed lighting and flame
brightness, press the "-" or "+" FLAME
buttons . There are four levels of brightness.
7