Nibe F370 User Manual page 53

tcp/ip settings
Menu
4.1.3.8 You can set TCP/IP settings for your
installation here.
Automatic setting (DHCP)
1. Tick "automatic". The installation
now receives the TCP/IP settings
using DHCP.
2. Mark "confirm" and press the OK
button.
Manual setting
1. Untick "automatic", you now have access to several setting options.
2. Mark "ip-address" and press the OK button.
3. Enter the correct details via the virtual keypad.
4. Mark "OK" and press the OK button.
5. Repeat 1 - 3 for "net mask", "gateway" and "dns".
6. Mark "confirm" and press the OK button.
Caution
The installation cannot connect to the internet without the correct TCP/IP
settings. If unsure about applicable settings use the automatic mode or
contact your network administrator (or similar) for further information.
TIP
All settings made since opening the menu can be reset by marking "reset"
and pressing the OK button.
proxy settings
Menu
4.1.3.9 You can set proxy settings for your
installation here.
Proxy settings are used to give connec-
tion information to a intermediate
server (proxy server) between the in-
stallation and Internet. These settings
are primarily used when the installa-
tion connects to the Internet via a
company network. The installation
supports proxy authentication of the
HTTP Basic and HTTP Digest type.
If unsure about applicable settings use the preset settings or contact your
network administrator (or similar) for further information.
Chapter 3 | F370 – at your service
tcp/ip settings4.1.3.8
automatic
ip-address
net mask
gateway
dns
confirm
proxy settings 4.1.3.9
use proxy
server
port
user name
password
confirm
reset
reset
NIBE™ F370 51