Connect The Cables - Cisco TelePresence SX10 Quick Set Installation Manual

Connect the cables

1. Connect the SX10 to your monitor with the provided HDMI monitor cable.
2. Connect the LAN cable from the SX10 to an Ethernet wall plug. If Power over Ethernet
(PoE) is available, the SX10 is powered through this cable.
If the network does not support PoE, use the optional power adapter, or a PoE injector.
Ethernet/PoE
Power
Power over Ethernet (PoE)
The PoE source (network switch or PoE injector) must be located in the same build-
ing as the SX10 device. The maximum cable length when connecting the SX10 to
a PoE source is 50 m / 164 ft.
NOTE: Do not connect an external device to the USB port.
Monitor output,
HDMI
Factory reset pinhole,
Micro USB
USB
(For future use)
Table microphone 20,
mini jack 3.5 mm
Presentation inputs
HDMI VGA
5
External active
speakers,
mini jack 3.5 mm