Step 5: Interactive Setup; Step 6: Place Batteries In The Remote Control; Step 7: Plug In And Turn On The Digital Satellite Receiver - RCA Digital Satellite Receiver User Manual

Hide thumbs Also See for Digital Satellite Receiver:

Table of Contents

Enlarged version

Setup and Connections

Step 5: Interactive Setup

If you self-installed your satellite dish antenna, you may have already

used the interactive setup to find the dish pointing coordinates, acquire

and fine-tune the signal, and run a system test.

If you need to run the interactive setup again, select Options from the

Main menu, then select Interactive Setup.

If you just want to check your dish pointing coordinates, or run the signal

strength meter, select Dish Pointing from the Main menu.

Step 6: Place Batteries in the

Remote Control

Follow these steps whenever you need to install or change the

batteries in your digital satellite receiver's remote control.

Remove the cover from the battery compartment.

Insert batteries into the battery compartment, matching

the + and – end of each battery.

Replace the cover.

STEP 7: Plug in and Turn on the

Digital Satellite Receiver

Plug the end into the wall outlet, matching the wide blade of the

plug with the wide slot in the outlet. Be sure to insert the plug

completely.

To turn on the digital satellite receiver, press the DIRECTV button on

the remote control or on the ON•OFF button on the front panel. If

your TV brand is RCA, GE, or P

remote to turn on the TV. If your TV brand is not RCA, GE, or

, see the next section, Using the Remote, for details on how

CAN

to use the remote to control your TV.

, press the TV button on the

CAN

Table of Contents