RCA Digital Satellite Receiver User Manual page 22

Using the Remote
Using the Remote to Control a Device
Once the remote has been programmed successfully, you are ready to
use it to control your devices.
To operate the device:
1. Press the device button (TV, VCR, DIRECTV, DVD, or AUX) to set the
remote to control the device.
2. Press ON•OFF to turn the device on or off.
3. Use the remote control buttons that apply to that device.
Modes of Operation
Because this universal remote can control several different components
(DVD player, VCR, Cable Box, etc.) it uses operational modes triggered by
the component buttons. For example, if you want the remote to control the
TV, you would press the TV button to put the remote into TV mode before
you could control the TV.
Using the Remote to Control a Second
Digital Satellite Receiver
The remote can control two digital satellite receivers. From the Main
menu, select Options, then System Options, then Remote Setup. Have
the AUX button control the second receiver, while the first receiver is
controlled by the DIRECTV button.
Changing the RF Remote Code
If your DIRECTV System is equipped with an RF remote, the remote can
control the digital satellite receiver using both IR (Infrared) signals and RF
(radio frequency) signals. IR signals require line-of-sight to the receiver's
front panel remote sensor. RF signals can control the receiver from other
parts of your house–even through walls.
Occasionally, due to interference or other RF devices, you may need to
change the remote and digital satellite receiver RF code. Change the code in
the System Options menu.
20