Plug In And Verify Router Hardware - HP 650 Installation Manual

N o t e

Plug in and verify router hardware.

If you will be installing a second power supply, it may be more conven-
ient to do so now; however, you can also install it later (without switch-
ing off the first power supply). For information about installing a second
power supply, refer to the documentation accompanying the HP J2446A
Redundant Power Supply.
The router automatically adapts to the correct ac voltage range for your
power source.
1. Plug a power cord into the power socket on the back of the router
nearest the side (the socket labeled "Factory-installed power
supply").
2. Plug the other end of the power cord into an ac power source.
3. Open the front door on the router, switch the power supply on by
pressing the top of the switch (marked with " | "), then close the door.
(While the power supply is connected to a power source and is
switched on, the LED on the power switch is lit.)
The router's self-test begins when the power is switched on. It can
continue for 15–35 seconds, depending on how many interface cards are
installed. During the test, the Status LED for the router is orange and the
Self-test LED for the routing engine (the second LED in the first row) is
green.
Installation
Plug in and verify router hardware.
1-17