HP 650 Installation Manual page 10

W a r n i n g
N o t e
1-6
Installation
Mount the router.
3. Position one of the two mounting brackets over the holes as shown
in figure 1-2. The edge of the bracket with the large hole in the center
should face the router, and the other bracket edge should face front.
Figure 1-2. Bracket Position
4. Using a Phillips (cross-head) screwdriver, secure the bracket to the
router with two 10-mm #M4 screws.
5. Repeat steps 2–4 to attach a bracket to the other side of the router.
The router weighs about 36 pounds (with no interface cards and
one power supply installed) . If the rack or cabinet is empty,
install the router at the bottom; if not, install the router as close
to the bottom as possible. (If a lightweight device is already
installed at the bottom, you may want to remove it, install the
router at the bottom, then reinstall that device above the
router.) If the router is mounted high, the rack or cabinet may
become unstable and possibly fall over.
The accessories kit includes both
Some racks and cabinets require #10-32 screws, others require #12-24
screws. Make sure you have the screws that are required for your rack
or cabinet before mounting the router.
⁄ ⁄
5 5
-in. #10-32 and -in. #12-24 screws.
8 8