Oven Sensor Replacement; Regulator Replacement; Oven Light Bulb/Oven Light Socket Replacement; Oven Vent/Smoke Eliminator Removal - Jenn-Air JDS8850BD Service Manual

Disassembly Procedures

Oven Sensor Replacement

1. Remove power from unit.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Label and disconnect wire terminals.
4. Reverse procedure to reinstall sensor.
NOTE: Verify sensor wires are pushed through the
insulation.

Regulator Replacement

1. Disconnect power before servicing.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Disconnect tubing from regulator.
4. Remove screws securing bracket to back of unit.
5. Remove screws securing regulator to support
bracket.
6. Reverse procedures to reassemble.
NOTE: When reconnecting supply line to regulator, use
pipe dope compound to seal the connection.
NOTE: Perform gas leak test.
Oven Light Bulb/Oven Light Socket
Replacement
The light automatically illuminates when the door is
opened. The light will not operate during a clean cycle.
1. Remove power from unit.
2. Open oven door and locate oven light.
3. Grasp lens cover and pull outward on one side to
gain access to the bulb.
4. Carefully remove old bulb by lifting bulb straight out of
base.
5. When installing the new bulb, place cover over socket
so the cut-out in the glass cover aligns with the base
on the socket.
NOTE: To avoid damaging the new bulb and
decreasing life of the bulb, do not touch new
bulb with bare hands or fingers.
Hold with a cloth or paper towel.
NOTE: Proceed with the following steps for oven light
socket removal.
6. Remove power to unit.
7. Remove screw securing light socket to oven cavity.
8. Label and disconnect wire terminals from light socket.
9. Reverse procedure to reinstall light socket.
NOTE: Reposition fiberglass insulation around light
socket to eliminate the possibility of any heat
related problems.
28
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas to range before
servicing, unless testing requires power and/or gas.
Bulb
Lens
G5.3 Type Halogen Bi-Pin 25W-120V

Oven Vent/Smoke Eliminator Removal

1. Remove power from unit.
2. Locate tabs on bottom of smoke eliminator and turn
counterclockwise to release locking ears.
3. Gently pull smoke eliminator down and align locking
ears with notches in oven cavity to remove.
4. Reverse procedure to reinstall smoke eliminator.

Oven Hi-Limit Thermostat Replacement

1. Remove maintop assembly, see "Maintop Assembly
Removal" procedure.
2. Remove screws securing hi-limit thermostat to oven
chassis.
3. Label and remove wire terminals.
4. Reverse procedure to reinstall hi-limit thermostat.
Door
Latch
Convection
Fan

Oven Door Latch Replacement

1. Remove control panel, see "Control Panel Removal"
procedure.
2. Remove screws securing door latch to the front of the
oven cavity outer shell.
3. Slide oven door latch assembly forward to diagnose.
4. Label and disconnect wire terminals from latch
assembly.
5. Reverse procedure to reinstall door latch assembly.
16026929
Socket
Bulb specifications
Hi-Limit
Thermostat
Oven
Light
Switch
Door Hinge
Receiver
© 2006 Maytag Services