Table of Contents
Advertisement
Connect the power cord as follows:
1.
Plug the supplied power cord into the power connector on the back
of the LASER CLASS 2060.
2.
Plug the other end of the power cord into the outlet.
N
The LASER CLASS 2060 has no power switch, so its power is on as long
as it is plugged in. Once connected, though, the unit still needs to warm
up before you can use it.
N
If the toner cartridge has not been installed yet, the message CHECK
COVER/CART alternates with the standby mode display:
2-22
Setting Up Your LASER CLASS 2060
While the LASER CLASS 2060 is warming up, the message
PLEASE WAIT appears in the LCD display:
When the date, the time, the receive mode, and the resolution
mode appear, the LASER CLASS 2060 is in standby mode and
ready for use:
P L E A S E W A I T
1 2 / 3 1 / 1 9 9 9 F R I 1 0 : 0 0
F a x T e l
S T A N D A R D
C H E C K C O V E R / C A R T
1 2 / 3 1 / 1 9 9 9 F R I 1 0 : 0 0
F a x T e l
S T A N D A R D
Chapter 2
Advertisement
Table of Contents
