Table of Contents
Advertisement
While you are adjusting the offsets, you can try out the new thresh-
olds as you are customising them by simply pressing pads [13],
[14], [15] or [16], and looking at the force-feedback LEDs [7] to
check how much force you need to apply to activate that particular
level for each individual pad.
•
When you are done adjusting the offsets, press the Favourite switch [4] to
return to browse mode or to favourite mode.
8.12 RE-INITIALISING THE PEDALINO
If you want to restore Pedalino's factory settings and reload the factory value
for user-defined thresholds, you can do that by re-initialising your Pedalino
Foot Controller.
In browse mode or in favourite mode press the MENU key [10] until the
•
top line of the display reads 'Initialise'.
I t
ni i al ise
•
Now press the SET key [11]. You will be asked to confirm the action by
pressing the SET key [11] again.
Sur e? Set=yes
•
Press the SET key [11] to confirm or the EXIT key [12], if you want to can-
cel the action.
23
How to Use Your Pedalino
8
Rev. 1.1 - EN EU - fw 4.10
Advertisement
Table of Contents
