Table of Contents
Advertisement
How to Use Your Pedalino
When you are using the tuner, the ADES ON/OFF switch [3] is deacti-
vated and you cannot interrupt the ADES connection with the Pedal-
Pro.
8.7
USING AN EXPRESSION PEDAL
Pedalino allows you to control in real-time a number of the parameters of
the analogue effects on your PedalPro using an expression pedal. The table
below gives you a list of compatible models.
Plug the expression pedal into the EXPR. PEDAL connector [18] at the
•
back of the Pedalino using a standard stereo patch cable. The EXP.
MODE switch [19] must be set according to the
A
at the end of this manual (p.28) if the expression pedal is to work cor-
rectly. You may need to use a pen, screwdriver or similar tool to set the
EXP. MODE switch [19] (it is recessed by design to prevent accidental
switching).
•
Now assign to the expression pedal the parameter you wish to control.
You must do this via the ADES menu page on the PedalPro. Please refer
to the PedalPro Owner's Manual for details on how to do this.
•
Load the preset using your Pedalino and following the steps detailed in
sections
8.1
and 8.2. The display of the Pedalino will now look like this:
CryClass=11
008 Ø CryBabyWdÖ
8
The top line of the display indicates the name of the parameter that you can
control in real-time, and its current value.
Using the expression pedal, you can now sweep in real-time through the
predefined range* of that parameter. For extra information on the list of
available parameters that you can control in real-time, and their predefined
ranges, see the section below:
*VR can supply customised ranges for all the available parameters – see
Rev. 1.1 - EN EU - fw 4.10
table shown in Appendix
00 Hz
'ADES - An In-Depth
Look'.
section 9.2
(p.24) .
Please check the table in
Appendix A
shows the correct position of EXP. MODE switch [19] when using some of the
most popular expression pedals on the market. If your expression pedal is not
shown in the table, you may have to experiment with the position of EXP.
MODE switch [19] in order to find the appropriate setting.
The PedalPro is disabled when the ADES connection between the
PedalPro and Pedalino is active. If you want to create or modify the
assignment to your expression pedal of an effect's parameter, you
must first temporarily disconnect the two units using the ADES ON/
OFF switch (3). Once you have made your modifications, save the
preset. Now press the ADES ON/OFF switch again to reconnect the
Pedalino to the PedalPro, and try out your new expression param-
eter setup.
8.8
USER-DEFINED EXPRESSION PARAMETER RANGES*
Pedalino allows you to customise the ranges of some of the expression
parameters associated to your expression pedal. This allows you to define a
precise range for the parameters you want to control in real-time that exactly
matches your expression requirements.
You will find a list of the expression parameters with customisable ranges indi-
cated with the symbol @ in the
How to customise an expression parameter range
Press the MENU key [10] until the top line of the display reads 'Expression
•
range'.
E
xp essi o ra
r
•
Press the SET key [11] to access the range configuration page.
* Requires optional firmware pack for Pedalino.
14
at the end of this manual. The table
table
on page 16.
n
n
ge
Advertisement
Table of Contents
