Table of Contents
Advertisement
With the PedalPro switched ON
If the PedalPro is already ON when the Pedalino is switched ON, the calibra-
tion process will take place as above. Please do not touch or press the pads
until the calibration process is complete.
Once calibration is complete, the ADES connection will be automatically
established and you will see the following:
000 Ø PurePhaser
The preset number and name indicate the preset that is currently loaded on
the PedalPro. At the same time, the display on the PedalPro will show:
* A
D
This indicates that the PedalPro can now be completely controlled using the
Pedalino, and that the controls on the PedalPro are DISABLED. This screen will
remain for as long as the PedalPro is controlled by the Pedalino Foot Control-
ler. You are now ready to go.
Expression Pedal
After connection with the PedalPro has been established, if there is no ex-
pression pedal attached to EXPR. PEDAL connector [18], the display will show:
no expr. p
000 Ø PurePhaser
After approximately three seconds, this first line will clear.
E
S ON
*
ed l a
The display does NOT indicate the presence of the expression pedal when
the expression pedal is attached but not associated to any parameter of the
preset currently loaded.
If you have loaded a preset where one of the parameters can be controlled
by the expression pedal, the display of the Pedalino will look something like
this:
CryClass=11
008 Ø CryBabyWdÖ
The top line of the display shows the parameter currently controlled by the
expression pedal and its instantaneous value. In the example above, it's the
centre frequency of the PedalPro inductor filter F1. The centre frequency is
currently set at 1.1 kHz (see the special section
page 9, for more information).
The symbol
Ö
may be manually appended to the name of the preset to act
as a reminder that one of the parameters of that preset has been assigned
to an expression pedal.
7.3
SWITCHING OFF
BEFORE switching off the Pedalino, press the ADES ON/OFF switch [3] to inter-
rupt the ADES connection between the PedalPro and the Pedalino. This ac-
tion will be indicated by the corresponding ADES ON/OFF green LED [3] going
off.
You will now see the screen on the PedalPro go back to its normal operating
mode, and the Pedalino can be switched off using the POWER switch [20].
If you switch off the Pedalino BEFORE interrupting the ADES connec-
tion between the two units, the PedalPro will be locked in the ADES
remote control mode. You will need to reboot it (powering it OFF and
ON) in order to be able to operate it again.
9
Setup Guide
00 Hz
'ADES - An In-depth
Look' on
Rev. 1.1 - EN EU - fw 4.10
7
Advertisement
Table of Contents
