NutriMill Classic Owner's Manual & User Manual page 5

Hopper Lid
• Use during milling for quiet
operation
Hopper
Grain Inlet Cover
Variable Motor Speed Control
Knob
Variable Texture Control
Knob
Circuit Reset Button (Red)
• Located at the bottom of the
Milling Module Unit
Separator Cup
• Must be attached when
milling
• For air fi ltration
• Prevents Flour Leakage
Flour Bowl (Canister)
• Large 20 cup capacity
• Large easy grip handles
Locking Pin
• This knob at the back of the
mill fi rmly holds the mill unit
to the base
*Inlet grommet and fi lter should be replaced every 2 years or as needed.
Hopper Extension Ring
• Comes packed inside the fl our
bowl
• Must always be removed from
bowl before milling
• Increases grain capacity
• Not necessary to use when
milling small amounts of grain
Milling Module Unit
*Inlet Grommet*
Air Filter*
• Must be dry and in place
when milling
• Helps air fl ow
• Prevents fl our leakage during
milling
Base
• Yes/No bowl position indicator
on front of base helps
position bowl into place
• Bowl must be pushed in far
enough to reveal "YES" line on
the base.
• It can be removed with a twist
to separate sections for storage,
cleaning, or for use with the NutriMill
Classic optional Flour Bagger
accessory.
5