Fax Maint; Dtmf Test; Modem Test - Konica Minolta bizhub C35 Service Manual

DRAFT
10. SERVICE MODE
10.7.26

Fax Maint.

A. Use
• Check a signaling tone by connecting the machine to the line to output a test signal of the
fax board.
B. Procedure
• The default setting is G3 Maint Off-Hook.
"G3 Maint Off-Hook"
G3 Maint Ansam
G3 Maint Modem
• The signaling tone can be checked with a monitor speaker.
1. Call the Service Mode to the display.
2. Touch [Service Fax Setting]
3. Select the signal to be checked and touch [OK].
4. Check the signaling tone.
5. Touch [Fax Maint.].
6. Select [G3 Maint Stop] and touch [OK] to stop the signaling tone.
7. Following the same steps, check other signaling tones.
NOTE
• "Once" or "All" must be selected for [Admin Settings]
→
Settings] [Line Monitor].
10.7.27

DTMF Test

A. Use
• Select the type of signal transmission at the start of the DTMF test.
B. Procedure
• The default setting is 0.
"0"
6
10.7.28

Modem Test

A. Use
• Select the type of signal transmission at the start of the modem test.
B. Procedure
• The default setting is V.34(33600bps).
"V.34(33600bps)"
V.17(9600bps)
V.27(4800bps)
138
G3 Maint CED
G3 Maint Ringtone
G3 Maint Stop
→
[Fax Maint.].
1 2
7 8
V.34(28800bps)
V.17(7200bps)
V.27(2400bps)
Field Service Ver. 1.0 Feb. 2010
G3 Maint CNG
G3 Maint DTMF
→
[Fax Settings]
3 4
9 *
V.17(14400bps)
V.29(9600bps) V.29(7200bps)
V.21(300bps)
→
[Comm.
5
#
V.17(12000bps)