Page 1
® Vidifox Document Camera DV 550S USER MANUAL Please read this User Manual thoroughly before you use the document camera. Keep the CD-ROM in a convenient place so you can use it quickly if you need to. Please visit us at http://www.waninusa.com where you can get product support, the latest driver...
Page 2
PRECAUTIONS NOTICES: PLEASE READ CAREFULLY BEFORE USE Use the document camera under the rated electric conditions. Do not place the document camera on any unstable surface. It may fall and cause injuries or damages. Do not place this device directly under sunlight or near heaters. ...
TABLE OF CONTENTS 1. PARTS IDENTIFICATION ..............5 2. CONTROL PANEL ................6 3. INPUTS AND OUTPUTS ..............7 4. REMOTE CONTROL ................. 8 5. CONNECTIONS ................... 9 5.1. COMPUTER CONNECTION ................... 9 5.2. USB CONNECTION ....................... 10 5.3. RGB INPUT AND OUTPUT ................... 10 5.4.
Page 4
IMAGE FREEZE ........................37 IMAGE ROTATE........................38 SPLIT SCREEN ........................38 TITLE FUNCTION ........................ 38 PICTURE IN PICTURE FUNCTION ..................38 IMAGE SAVE ......................... 38 IMAGE RECALL ........................38 RGB INPUT SWITCH ......................38 OUTPUT SWITCH ......................... 38 USB IMAGE CAPTURE AND VIDEO RECORDING ............38 USB 2.0 PORT ........................
1. PARTS IDENTIFICATION 1. LED light box 2. Remote control IR receiver 3. Camera 4. Rear panel 5. Side panel-1 6. Side panel-2 7. Base light 8. Control panel 9. LCD screen...
2. CONTROL PANEL : Turn on/off the power. 2. MENU ENTER: Enter the On-Screen Menu. 3. HOME: Output the image from the camera. 4. PC: Output the signal from VGA input. 5. VIDEO: Output the signal that from the C-Video/S-Video input. 6.
3. INPUTS AND OUTPUTS 1. DC 12V: Power input. 2. RS 232: Serial port, to control the document camera by a computer via this port. 3. COMPUTER & AUDIO IN: Computer signal (and audio signal) input. 4. COMPUTER OUT: Output the signal that from the COMPUTER IN connector. 5.
4. REMOTE CONTROL 1. Save: Capture the image in display. 2. Recall: a. Image recall mode enabled, display the saved images. b. When a USB drive is connected, press Recall to show the content that in the USB drive. c. Back to upper level in Image Recall mode. 3.
12. SXGA/XGA: Switch the output format between SXGA and XGA. 13. Blue+/-: Image color adjustment (blue). 14. PC 1/2: Switch the input between PC1 and PC2. 15. Video 1/2: Switch the input between Video1 and Video2. 16. Menu Enter: a. Active the on-screen menu. b.
5.4. DVI OUTPUT Rear panel To DVI Input DVI Cable 5.5. C-VIDEO & S-VIDEO INPUT To Audio Output(L) Player 1 Audio cable To Audio Output(R) To Video Output Video cable Side panel-2 To S-Video output Player 2 S-Video cable To audio output(L) Audio cable To audio output(R)
5.6. C-VIDEO & S-VIDEO OUTPUT Side panel-1 TV-1 To Audio Input Video cable TV-2 To S-Video Input S-Video cable 6. RS232 SOFTWARE 6.1. COMPUTER REQUIREMENTS The PC's hardware and software configurations shall not be less than the following requirements: Operating system: Windows XP CPU: 1.8GHz Physical memory: 512M Video memory: 64M...
Page 13
Read terms, select "I accept the terms in the license agreement" Click Next: Click Change to change the installation directory if needed, then click Next:...
Page 14
Click Install to install the software to the computer:...
Click Finish, the software installation is complete: 6.3. SOFTWARE SETTINGS Connect the computer and the DV 550S with a RS232 cable, turn on the power of DV 550S, then double click on or click start->All Programs->Visualizer_RS232-> Visualizer_RS232.exe to run the RS232 software, you will see the Icon...
Page 16
Click on , you will see the following control panel. Setup the software properly: Select corresponding model number. Select the right COM port Note: * If the selected model does not have certain functions, the corresponding buttons in the software interface are displayed in light gray and are not clickable.
6.4. BUTTON INSTRUCTION Button Function Power the unit on Power On Stand by Power Off Visualizer output mode Home Video 1 input Video1 In Video 2 input Video2 In PC1 input PC1 In PC2 input PC2 In Image freeze Freeze Toggle between arm light, backlight and light off modes Light Brightness+ Increase the brightness...
Page 18
Increase the blue hue Blue+ Decrease the blue hue Blue- Sharpness+ Increase the sharpness Decrease the sharpness Sharpness- Auto focus, brightness and color Auto Save image Save Recall saved images Recall Switch between negative and positive modes Switch between black/white and color modes Split screen Split Mirror image...
550S, you can use it to annotate on the image. 2. USB stick * Connect the USB stick with DV 550S, then press Recall button to access the USB stick. * Use the left and right arrow to exit/enter a folder.
Page 20
Visualizer_USB(Vista x64): Windows Vista, 64bit. For Vista system, please do not choose “Use User Account Control (UAC) to help protect your computer”, follow the step to complete the setting: 1. Open the control panel, then click User accounts: 2. Click on “Turn User Account Control on or off”, you will see:...
Page 21
3. Do not tick the option “Use User Account Control (UAC) to help protect your computer”: For Windows 7, please change the User account control setting to Never Notify. Follow the step to complete the setting: 1. Click on the right key of the mouse, choose properties:...
Page 22
2. Click on Action center: 3. Click on Change User Account Control Setting, then choose Never notify.
7.2.3. SOFTWARE INSTALLATION Double click to run the software installation package, the following dialogue appears, click "Next": Read the terms, select "I accept the terms in the license agreement." Click "Next", as the following figure.
Page 24
The following dialogue box appears, click "Next": The default installation directory is Program Files, C: \ Program Files \, you can select a different installation directory, as shown:...
Page 25
Click on "Change" to change the directory, as shown: Click on "OK", the following figure appears. Click "Next".
Page 26
Click on "Install" to complete installation, as shown: Click on "Finish” to complete the installation, as shown:...
Then you will see the following interface, which is an installation package for 2005 environment. If your PC already has this installed, click on "No" to exit, otherwise, click on "Yes" to install it. 7.2.4. START THE SOFTWARE Note: To use the software, the document camera’s USB mode has to be set to USB Video mode. Please follow the instruction below: A.
Then click on , or select Video->Play, you will see the interface: 7.2.5 IMAGE CONTROL Zoom in and Zoom out Zoom In ( Ctrl+I): Left-click the Zoom In command button to enlarge the image. Zoom Out( Ctrl+O) : Left-click the Zoom Out command button to shrink the image.
Page 29
Focus adjustment Focus Far( Ctrl+R) : Left click the Focus Far command button to focus far. Focus Near( Ctrl+N) : Left click the Focus Near command button focus near. Image Brightness adjustment Bright More ( Ctrl+B) : Left click the Bright More button to increase the brightness. Bright Less (...
Image black and white/ color adjustment Mono/Color( Ctrl+K) : Left click the Mono/color button to toggle between the black-white and color modes. Positive and negative film images Neg( Ctrl+G) : Left click the Neg button to toggle between the positive and negative modes.
7.2.7. SETTING The captured images and recorded videos will be saved into the folders of Images and Videos respectively, which are created by the system automatically. To set a different path to which the image/video is be to saved, click on on the left side of the window, a pop up dialog box appears below.
7.2.8. IMAGE MODIFY Click on , you will see the interface: Grapic selection and move Click on to choose a line, circle, rectangle or curve that placed in the image, then move to another place. Line Click on to place a beeline in the image, shown as below:...
Page 33
Click on to change the setting of the chosen line: Line width: change the width of the line. X, Y: change the position of the line. Color: change the color of the line. Width, Height: Change the angle of the line. ...
Page 34
Line width: change the line width of the rectangle. X, Y: change the position of the rectangle. Color: change the line color of the rectangle. Fill Color: Tick it to fill color in the rectangle. Width, Height: Change the shape of the rectangle by changing the angle of two adjacent lines of the rectangle.
Page 35
Click on to change the setting of the chosen circle: Line width: change the line width of the circle. X, Y: change the position of the circle. Color: change the line color of the circle. Fill Color: Tick it to fill color in the circle. Width, Height: change the size of the circle.
Page 36
Click on to change the setting of the chosen curve: Line width: change the line width of the curve. X, Y: change the position of the curve. Color: change the line color of the curve. Graphic default setting Click on to change the setting of the graphic: ...
Press it again, the output image will be converted back to original color. FOCUS ADJUSTMENT When the DV 550S is turned on the focus automatically adjusts to the stage, it is usually not necessary to re-adjust the focus if you are only working with flat materials (text, photos, etc.).
USB IMAGE CAPTURE AND VIDEO RECORDING USB 2.0 PORT The USB port can be used to capture still images from the DV 550S into a computer. In this way, the DV 550Scan be used as a 3-D scanner for your computer.
Connect the DV 550S to your computer with the supplied USB cable. The capture software is available on the supplied CD-ROM. RS232 CONTROL The RS232 terminal allows you to integrate the DV 550S into any sophisticated central control system. RS232 also enables you to control the DV 550S via a computer.
Remote control Yes(360°controllable) Top Arm Light×1 (LED), 10” x 8” Lightbox (LED) Light source Kensington lock Operating temperature 32°F ~113°F Dimensions Folded:19.48"×14.56"×5", Setup: 21.25"×14.56"×21.25" Power supply 12V DC power adapter Weight(net) 11lbs/5kg 10. TROUBLE-SHOOTING: Symptoms Possible causes/counter-measures No image 1. Power cord is not properly connected. 2.
11. PACKING LIST Item Quantity Power cord Power adaptor(12V/2A) VGA cable S-Video cable Video cable with RCA RCA to mini adapter Mini jack audio cable USB cable(2.0) RS232 cable Remote control User manual(CD)
12. TECHNICAL SUPPORT Wanin USA is committed to providing highest possible stand of customer service. We can be reached: By Phone Call us at 1-877-369-3130. Our technical support staff provides technical assistance from 9:00AM through 5:00PM Pacific Standard Time, Monday through Friday. Please gather the following information before calling: - Product model name(s) and numbers - Product serial number(s)
Need help?
Do you have a question about the DV 550S and is the answer not in the manual?
Questions and answers