Munters JAZ 42 Operator's Manual
  1. Manuals
  2. Brands
  3. Munters Manuals
  4. Heater
  5. JAZ 80
  6. Operator's manual

Munters JAZ 42 Operator's Manual

Direct-fired diesel/kerosene air heaters
Hide thumbs

Advertisement

Table of Contents

Operator's Manual
JAZ
Direct-fired
GB
Diesel/Kerosene Air Heaters
JAZ 42
JAZ 80
JAZ 80 W
JAZ 125
JAZ 160
IMPORTANT:
Read and understand this manual before
assembling, starting or servicing the heater. Improper use
of this heater can cause serious injury. Keep this manual
for future reference.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JAZ 42 and is the answer not in the manual?

Questions and answers

Related Manuals for Munters JAZ 42

Summary of Contents for Munters JAZ 42

  • Page 1 Operator’s Manual Direct-fired Diesel/Kerosene Air Heaters JAZ 42 JAZ 80 JAZ 80 W JAZ 125 JAZ 160 IMPORTANT: Read and understand this manual before assembling, starting or servicing the heater. Improper use of this heater can cause serious injury. Keep this manual...
  • Page 2 Introduction Thank you for choosing a Munters product. Read this manual carefully before using the unit and save it for future reference. Disclaimer Munters reserves the right to make alterations to specifications, quantities, dimensions etc. for production or other reasons, subsequent to publication.

  • Page 3: General Safety Information

    1. General Safety Information Not for home or recreational vehicle use This is the safety alert symbol. It alerts you to Local laws and regulations may limit or potential personal injury hazards. Strictly prohibit the use of this type of heater. obey all safety messages that follow this Consult your local fire department for further symbol.

  • Page 4: Product Description

    4. Assembling Instructions JAZ 42/JAZ 80: the heater is fully assembled - no further assembly required Remove the heater from its shipping carton. If the unit is damaged in anyway, do not use it and JAZ 80 W contact your dealer.
  • Page 5 List of contents Description Handle End cap Upper shell Screw M5×8 Screw M5×30 Washer D.5 Nut M5 Axle Washer Spacer Wheel Cap nut Knurled nut Support bracket Fig. 1 Before adding fuel, installation use, Slide axle (8) through the two tubes on the tank assemble the loose parts as follows (see Fig.
  • Page 6 JAZ 160 List of contents Description Axle Axle bracket Spacer Wheel D.200 Cap nuts Screw M5x16 Washer D.5 Nut M5 End cap Rear handle Front handle Screw M5x30 Fig. 3 Before installation and use, assemble the loose MINIMUM SAFETY CLEARANCES FROM parts as follows (see Fig.

  • Page 7: Operation

    CO poisoining may lead to death. Early signs of CO poisoning are headache, JAZ 42/80/80W: the sightglass on the right side dizziness and/or nausea. If you have these of the tank allows the user to see when fuel level signs, get fresh air at once, shut off the is getting low (see Fig.

  • Page 8: Abnormal Operation

    1. Thermostat Control Knob 2. Green Indicator Light 3. On/Off Switch 4. Fuseholder 5. Power Cord Socket Fig. 7 ignition attempts. Unplug heater and remove excess accumulated fuel before attempting restart. To Start the Heater 1. Turn the ON/OFF switch (3) to the ON (“I”) Never leave heater...

  • Page 9: Recommended Maintenance Schedule

    wetted with lukewarm water mild detergent, then dry using a clean cloth. Keep air inlet and fan free from dust and dirt. To clean inner parts, gently blow compressed air through air inlet. Regularly inspect the power cable: if worn, cracked or damaged replace it with an original spare part.

  • Page 10: Wiring Diagram

    (at right) required for your model. If adjustment Model Air Pressure (psi) of air pressure is required, loosen the hex nut at JAZ 42 the Air Vent Hole and turn the pressure JAZ 80 adjustment screw (2) with a 5/32 inch or 4mm...
  • Page 11 PROBLEM POSSIBLE CAUSE SOLUTION Motor will not start No power or low voltage Check power supply and voltage. Reset: Turn On/Off switch to O and then to I [needed here?] GREEN INDICATOR LIGHT IS QUICKLY FLASHING Fuse is blown. Replace fuse. (4 flashes/second) Thermostat is set too low.
  • Page 12 Allow motor to cool and restart. Identify and Motor Overheating correct cause of overheating. If needed, call Customer Service. Faulty or Dirty Photocell (Flame Clean or replace photocell Sensor) Faulty Control Board Replace control board For Spot Climate Control Customer Service (9 am to 5 pm EST): Call (239) 936-1555 and select SCC Customer Service.
  • Page 13 333, Japan Munters K.K., Phone +81 3 5970 0021, Fax +81 3 5970 3197, Kingdom of Saudi Arabia and Middle East Hawa Munters, c/o Hawa United Cooling Syst. Co. Ltd., Phone +966 1 477 15 14, Fax +966 1 476 09 36, Korea Munters Korea Co,. Ltd, Phone +82 2 761 8701, Fax +82 2 761 8777, Mexico Munters Mexico Phone +52 722 270 40 30, Fax +52 722 270 41 95, Norway via sales organization in Sweden, South Africa and Sub-Sahara Countries Munters (Pty) Ltd, Phone +27 11 997 2000, Fax +27 11 608 3501, Spain Munters Spain S.A., Phone +34...

This manual is also suitable for:

Jaz 80 w

Table of Contents