Getting Started; Accessory List; Location Of Controls; Turning Power On Or Off - Alpine INE-W940E Owner's Manual

Getting Started

Accessory List

• INE-W940E ..........................................................................1
• Power cable.........................................................................1
• Flush head screw (M5×8)....................................................6
• Screw (M5×8) ......................................................................8
• AUX/PRE OUT cable ...........................................................1
• GPS Antenna .......................................................................1
• Antenna mounting plate ......................................................1
• Cable clamp ........................................................................3
• USB extension cable ...........................................................1
• Microphone..........................................................................1
• Mounting sleeve ..................................................................1
• Face plate............................................................................1
• Bracket key..........................................................................2
• Owner's Manual ..............................................................1set

Location of Controls

c (Eject) button
Ejects a disc.
Remote Sensor
Point the remote control transmitter towards the remote
sensor within a range of 2 metres.
(MAP) button
Recalls the navigation map screen.
Press and hold this button at least 3 seconds to Dual
Screen. Refer to "About Dual Screen" (page 15).
(PHONE) button
Recalls the Telephone Menu screen.
When a hands-free phone is connected, press and hold for
at least 3 seconds to switch to the call history screen.
(AUDIO) button
Displays the Audio/Visual screen. If the Audio/Visual screen
is already displayed, changes the source. Press and hold
AUDIO for at least 3 seconds to activate the "Setting the
Balance/Fader/Subwoofer" mode.
/ (UP/DOWN) button
Press to adjust the volume.
MUTE/C button
Press to activate /deactivate the mute mode.
Press and hold for at least 3 seconds to turn the power off.
DISC Slot
Optional Remote Control Interface Box
This unit is operable using the vehicle's secondary radio controls.
An Alpine Remote Control Interface Box (optional) is required. For
details, contact your Alpine dealer.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote control sensor.
About the button descriptions used in this Owner's
Manual
The buttons found on the face of the unit are expressed in
bold (e.g. MUTE). The buttons found on the touch-screen
display are shown in bold within brackets, [ ] (e.g. [

Turning Power On or Off

Some of this unit's functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Turn the ignition key to the ACC or ON position.
The system turns on.
• When turned on, the system displays the last mode screen that
was displayed before the ignition key was turned off. For
example, if the unit is in radio mode when ignition is turned off,
it will remain in radio mode when ignition is turned back on.
2
Press and hold the MUTE button for at least 3
seconds to turn the power off.
• The unit can be turned on by pressing any button.
• The INE-W940E is a precision device. Careful handling of the unit
should provide you with years of trouble-free operation.
]).
13
-EN