Getting Started; Location Of Controls; Using Face Cover; Initial System Start-Up - Alpine VPE-S431 Operating Instructions Manual

Getting Started

5
3
1 2 4

Location of Controls

1 Rotary encoder
Adjust the volume by turning to the left or right.
If pressed, the audio adjusting screen is displayed.
If pressed for at least 2 seconds, MUTE is switched to ON
or OFF.
2 Access Indicator
Blinks when an operation is performed (except when the
volume is adjusted).
3 Remote Sensor
Point the optional remote control transmitter toward the
remote sensor within a range of 2 m.
4 SOURCE/POWER button
Turns the power on. Press and hold for at least 2 seconds
to turn the power off.
Recalls the source selection screen.
5 BAND/TEL. button
Radio mode: Changes the band.
Visual source (except navigation screen): Changes the
display mode.
Press and hold for at least 2 seconds to change to the
TEL. mode, and to be able to place or cut a call. (When
MobileHub (CXA-B200NK) is connected.)
6 V.SEL/OFF button
The visual selecting screen is displayed.
Press and hold for at least 2 seconds to cancel the
Simultaneous function.
7 V.SEL Indicator
Lights when the simultaneous function is activated. (See
"Switching the Visual Source Only (Simultaneous
Function)" on page 25.
8 RESET Switch
Be sure to press the RESET switch when using the unit for
the first time, after changing the car battery, or when an
operation cannot be performed.
9 T.INFO/RDS button
Turns the T.INFO mode ON or OFF.
Press and hold for at least 2 seconds to display the RDS
screen.
! DISC-IN Indicator
This indicator is lit when a disc is inserted.
8
!
67 9 " #
" c button
Ejects a disc.
# OPEN/CLOSE/FLAT button
Raises the monitor.
Press and hold for at least 2 seconds to lower the monitor.
Press to move the open monitor to the flat position.
About the expression of buttons in this Owner's
Manual
• The buttons on this unit are expressed in bold (e.g. SOURCE/
POWER). The touch buttons on the display are expressed in
bold with [ ] (e.g. [SRC]).
• This Owner's Manual explains mainly the function of touch
buttons, when a touch button and a unit button have the same
function.
Compatibility with Factory Steering Wheel Radio
Controls
If your vehicle has steering wheel controls for the radio,
an optional steering wheel control interface may be
available to connect to your Alpine radio. For details,
contact your Alpine dealer.

Using Face Cover

An anti-theft face cover is provided with the
IVA-D300R/IVA-D300RB.
Put the face cover onto the IVA-D300R/IVA-D300RB
when you leave the vehicle.
Be sure to remove the anti-theft face cover when you
drive.

Initial System Start-Up

Immediately after installing or applying power to the
unit, it should be initialized. Press the RESET switch
with a ballpoint pen or any other pointed object.
• If the monitor was open before resetting, it will close automatically
after a reset is performed. None of the buttons will function while it
is closing.
9
-EN