Alpine INE-W940E Owner's Manual page 80

5
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the INE-W940E and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*1) already attached
to the vehicle's chassis. Connect all the leads of the
INE-W940E according to details described in the
CONNECTION section.
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
• For the screw marked "*2," use an appropriate screw for the chosen
mounting location.
6
Slide the INE-W940E into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
80
-EN
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
This unit
Bracket keys
(Included)
Installation using the Mounting Bracket
Take the face plate off, and secure the ground lead of the unit to a
clean metal spot using a screw (*) already attached to the car's
chassis.
Attach the Original Mounting Bracket to each side of the INE-W940E,
using the screws supplied with INE-W940E.
Ground Lead
Mounting
Bracket
Chassis
Screws (M5 × 8) (Included)
Face Plate (Included)