Chapter Ii: System And Network Setup; Installing The Range Extender To Your Network - Hawking HWREN1 User Manual

Chapter II: System and Network Setup

2-1 Installing the range extender to your Network

Please follow the following instruction to build the network connection
between your new wireless range extender and your computers, network
devices:
1. Connect the range extender to the wireless router(source) in your
network through the LAN port of the range extender by Ethernet
cable.
2. Connect the A/C power adapter to the wall socket, and then connect it
to the 'Power' socket of the range extender.
3. Please check all LEDs on the front panel. 'PWR' LED should be
steadily on, LAN LEDs should be on if the range extender is correctly
connected to the router. If PWD LED is not on, or any LED you
expected is not on, please recheck the cabling, or jump to '4-2
Troubleshooting' for possible reasons and solution.
7