Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual page 56

4. Use a clean rag to apply a coat of MinWax Wpe-On Poly Clear Satin.
product that is thick enough to provide a decent finish, but thin enough to soak straight into the
wood without running or dripping. Pour a little product into a disposable metal or plastic cup, like
the bottom inch cut from a soda can. Dip your rag and apply a generous coat to the whole
cabinet, inside and out.
175
177
179
5. Very lightly hand sand the exterior of the cabinet with 320 grit sandpaper.
it's done. The finish is thin, so be careful you do not remove the poly and damage the stained
wood underneath. You are trying to strike off the fuzzy grain raised in the finishing process so far.
This sanding should produce a fine white powder that feels soft as velvet to the touch.
off with a clean cloth.
Set it back down on its back to dry thoroughly, like, overnight.
176-178
182
56
175
176
178
This is a remarkable
179
Ignore the interior;
180
Wipe it
181