Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual page 50

146
148
14. Now attach the BOTTOM to the same SIDE, driving the screws barely snug.
150
15. Now apply glue to the remaining exposed ends of both the TOP and BOTTOM.
into the remaining SIDE and maneuver them into all four little pilot holes.
tighten the bar clamp (not shown; very foolish of us to attempt this without the clamp). Carefully
drive the two screws barely snug, then align the last joint, and set the last two screws, barely
snug. See also our online video for proper placement of the bar clamp.
154
147
149
50
150
Fit four screws
151
Align one joint and
152 153