Installing The Grill - Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual

INSTALLING THE GRILL

1. Fit the grill frame into the front of the cabinet, above the amp. Push it in tflush to the cabinet front.
It should be an easy fit side-to-side; it may be a tight fit up-and-down.
2. Fit a 1/16" drill bit to stick about 1-1/8" out of your screw gun, or use your combo piloting bit.
Center the grill frame left and right. Carefully pass the bit through the countersunk hole in the
cabinet top and drill a pilot hole in the frame. Next, drill the other two holes through the sides of
the cabinet into the sides of the frame.
227
3. Run a #6x1-1/4" wood screw (Part # SC61) through the hole in the top of the cabinet and into
the top of the grill frame. Repeat for the two side screws. Do not over-tighten the side screws; you
just want to hold the frame in place, not pull it apart!
228
That's it! You are done!! Congratulations.
227
228, 229
229
68