Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual page 46

130
5. Stand up all four pieces of wood on their FRONT edges on your clean, smooth, flat work surface.
Dry-fit them together. Use the bar clamp to snug the pieces together as shown.
has no plastic pads, DO NOT OVERTIGHTEN or you'll mar the wood. It just needs to be snug.
Pick one corner and line up the pieces of wood as carefully and accurately as you can.
the faces (the sides touching the table) are flush to each other at the joint.
precisely the same width (it happens), they will be a tiny bit uneven on the back face (that is, the
sides facing up). That's okay; don't worry about it – it's the back. You can fix it later when finishing
the cabinet.
When you are satisfied with the alignment of one corner, tighten the clamp to secure the parts
for drilling.
Take your time with this step. The overall neatness of your cabinet depends on getting this step right.
131
133
6. Fit your drill with the 1/16" bit, sticking out about 1-1/8". These break easily; you may want to
pick up a spare. At the corner you lined up, drill two holes at your marks, through the side and
into the mated wood piece.
132
134
135
46
131
If your clamp
132
Be sure
133
If the parts are not
134