Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual page 48

INNER holes, further away from the corners. They are for mounting the chassis and need to be as
accurate as possible. A drill press is great for this if you have one. Otherwise, be careful to hold
the drill perpendicular to the wood surface. Drill and countersink a total of 15 holes.
138
When you countersink, practice on the four bottom holes, where the depth is less critical. Go
easy, test-fit a screw, and deepen the countersink a little as necessary. The head should sit below
the surface of the surrounding wood, but only just.
140
10. With the 3/16 bit, drill the two holes in the cabinet top for the handle screws.
NOTE: If you use a handle other than the one provided, check the screw size before drilling
these two holes in the cabinet top!
141
139
140
48
138, 139
141