Zeppelin Design Labs THE PERCOLATOR Assembly Instructions Manual page 29

9. Wiring the PCB: Once the PCB is affixed to the chassis you can attach the transformer wires. All
of the wires will pass around the side of the PCB, and you will solder them on the component side
of the board.
a. Output transformer: Place the red wire into the square hole of P1, and then the blue wire to
the round hole of P1. Solder both connections.
78
b. Power transformer: Place the black wires into the holes of P4; it doesn't matter which wire
goes in which hole.
wires into the holes of P3.
but MAKE SURE YOU MATCH THE COLOR TO THE CORRECT NUMBER! Solder all the wires
in their respective holes.
79
81
10. Grounding Wire (Part # CB10.3): Strip about 1/4" (6mm) of insulation off both ends of one of
the 4cm hookup wires. Using your needle nose pliers, bend a small hook in one stripped end of
Place the red wires into the holes of P2
79
In each pair, it does not matter which wire goes in which hole,
81
80
29
78
, and then place the brown
80