Remote-Starting Your Vehicle; Setting Your Vehicle Into Ready Mode; Remote-Starting - Directed Electronics PS-4461TWE-FM User Manual

F Button Function
Menu
Function Button
programming
Remote Starting Your Vehicle

Setting Your Vehicle Into Ready Mode

If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle. Please note that Ready Mode can be enabled by the
remote or the handbrake, depending on the option that was selected by your installer. Therefore,
you must follow the appropriate procedure between the two described below in order to set your
vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold , or on
the transmitter.
The parking lights will flash 3 times quickly
and remain lit.
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either:
x
to lock the doors and shut down the engine;
x
to unlock the doors and shut down the engine;
x
to shut down the engine without affecting the doors.
7. The icon will appear on your screen.
Remote starting
1. Press the button for approximately 1 second and release.
2. The remote will beep once and the LCD will display "START".
3. The remote will confirm the remote starter's activation by beeping 3 times.
User Guide
FBPRO Function Button Programming
1 2 3 M Level 1, level 2, level 3, MENU
2 3 1 M Level 2, level 3, level 1, MENU
3 1 2 M Level 3, level 1, level 2, MENU
2 1 3 M Level 2, level 1, level 3, MENU
M 1 2 3 MENU, level 1, level 2, Level 3
If Ready Mode is enabled by handbrake
2. With the engine already running, apply the
parking brake twice within 10sec.
Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
Skip to step 4.
-
P.9