Download Print this page

STRIKEMASTER Solo Magnum Operating Manual page 9

Ice auger

Advertisement

WARRANTY
The manufacturer warranties trouble-free quality
and will cover the cost of replacing parts which are
found to be faulty in material or workmanship within
the prescribed warranty period after the date of
purchase. Please note that specific warranty
conditions may vary from country to country. If in
doubt, ask your equipment vendor. He is responsible
for warranty matters. Solo Inc. provides the initial
purchaser with a 2 year engine warranty.
We hope you will understand that we cannot be
liable for damage resulting from the following causes:
• Non-compliance with the operating instructions.
• Neglecting essential maintenance and repair work.
• Damage caused by incorrect carburetor adjustment.
• Wear in normal use.
• Obvious overload by continuously exceeding the
maximum performance limit of the product.
• Using non-authorized tools.
• Use of force, incorrect treatment, misuse and
accidents.
• Damage from excessive heat due to dirt buildup
around the cooling fan housing.
• Attempted adjustments and repairs by unqualified
persons.
• Use of unsuitable spare parts or third party parts, if
these are the cause of the defect.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire or
rental industry.
Normal cleaning, adjustments or maintenance work
fall outside the warranty provisions.
A service center authorized by the manufacturer
must carry out all warranty work.
PARTS SUBJECT TO WEAR AND TEAR
Various parts are subject to application-specific or
normal wear and must be replaced in good time, when
required. The following parts are subject to normal wear
and are not covered by the manufacturer's warranty:
• Air filter
• Fuel filter
• All rubber parts which come into contact with fuel
• Clutch
• Spark plug
• Starter (Recoil)
• Blades
Solo® Germany The registered Solo® trademark is licensed for
use in the U.S. to the German company Solo Kleinmotoren Gmbh
by the U.S. affiliate, Solo incorporated.
LIMITED WARRANTY
CE DECLARATION OF CONFORMITY
In accordance with EG Directives 98/37/EC,
2000/14/EC and 89/336/EEC (amended by
92/31/EEC), SOLO Kleinmotoren GmbH,
Stuttgarter Strasse 41, D-71069 Sindelfingen,
being solely responsible, states that the product
referred to in this declaration complies with the
requirements of the Machinery Directive.
Description of product: Ice Auger
Model/Type description
Sound power level
Guaranteed sound
Actual sound
(EN ISO 3744, EN ISO 22868)
Applied standards: EN ISO 12100, EN 11806,
ISO 14865, EN ISO 14982
Conformity assessment procedures
(98/37/EG)
(2000/14/EG)
Serial number, Build year
This declaration of conformity loses its validity, if
the equipment is converted or modified without the
manufacturer's consent.
Sindelfingen, 1st January 2006
SOLO Kleinmotoren GmbH Wolfgang Emmerich
Executive Director
FOR USA ONLY
Emissions Control Warranty Statement
The Environmental Protection Agency and Solo are
pleased to explain the emission control system on your
small non-road power equipment engine. In the US new
small non- road engines must be designed, built, and
equipped to meet the Environmental Protection
Agency's standards. Solo must warrant the emission
control system on your small non- road engine for the
period of time listed below provided there has been no
abuse, neglect, or improper maintenance of your small
non-road engine.
Your emission control system includes parts such as the
carburetor, the ignition system, and the exhaust system.
Where a warrantable condition exists, Solo will repair
your small non-road power equipment engine at no cost
to you including diagnosis, parts, and labor.
Manufacturers Warranty Coverage
Solo's small non-road power equipment engines are
warranted for a period of two years. If any emission
control related part on your engine is defective, the part
will be repaired or replaced by Solo.
Contact Information for Authorized Service Center
Locations, Replacement Parts,
Warranty and Technical Information:
Warranty repairs must be completed by a SOLO
Authorized Service Center.
SOLO USA, Inc. 1-800-765-6462
5100 Chestnut Avenue
Newport News, VA 23605
www.solousa.com/support
techserv@solousa.com
9
137
112
111
Appendix V
Appendix V
Type plate
142
154
112
112 dB(A)
111
111 dB(A)

Advertisement

loading

This manual is also suitable for:

Solo lazer magSolo pro lazer