Advertisement
Thoroughly read these operating instructions before
undertaking any maintenance, installation and cleaning steps.
It is recommended that everyone who uses this product should read the StrikeMaster
OPERATING MANUAL and the engine OPERATOR'S MANUAL before operation in addition to
viewing the enclosed safety DVD.
1.
DO NOT
use this product for any purpose other than cutting ice fishing holes. Ice augers
are precision cutting tools built for the ice fisherman, and must be properly maintained
and handled with caution during both cutting and transporting. When not in use, always
store with blade guard attached.
2.
DO NOT
use attachments and parts other than those available from the manufacturer.
3.
DO NOT
alter this product in any manner; doing so is dangerous and voids all warranties.
4.
DO NOT
allow children or adults weighing under 100 lbs. to operate this equipment.
5.
DO NOT
allow your body, loose clothing, drawstrings, scarves, hats or other materials to
come in contact with the Powerhead, Starter Assembly or Auger (Drill) unit at any time.
6.
DO NOT
operate under the influence of drugs or alcohol.
7.
DO NOT
operate if, upon pulling the starter rope or after drilling holes, the auger (drill)
unit rotates or if the rope pulls hard.
qualified mechanic.
8.
DO NOT
allow the engine to run or operate while moving or transporting to another
location.
9.
DO NOT
continue to use this product in the event of mechanical or electrical failure.
10.
This product produces considerable cutting force that is felt by the operator. Make sure
your feet are firmly planted and that the handles are held firmly while operating this product.
11.
Always check the operation of the throttle system to ensure the carburetor control is
completely returning to the idle position when the throttle lever is released.
12.
Check cutting blades and auger shaft screws before and after each use to make sure they
are tight.
13.
During operation, the auger unit could possibly stop. Be prepared at all times to release
the throttle lever.
14.
Everyone who uses this product should read this operating manual before operating
this unit.
15.
The cutting blades on the ice auger are razor sharp. Use extreme care when handling.
16.
The manufacturer recommends that all StrikeMaster augers be used for ice cutting only.
IMPORTANT SAFEGUARDS
DO NOT
3
OPERATE. Have the unit checked by a
Advertisement
