Chapter 2 Installing The Model 281Xsa Hub; Site Preparation - Bay Networks 281xSA Using Manual

Chapter 2

Site Preparation

893-743-A
Installing the Model 281xSA Hub
This chapter describes how to install the Model 281xSA hub. This chapter
includes information on the following topics:
Preparing the installation site
Unpacking the equipment
Installing the hub on a table or shelf
Attaching wall-mounting brackets and installing the hub on a wall
Attaching rack-mounting brackets and installing the hub in an equipment
rack
NOTE: Only qualified technicians should install and maintain this
equipment.
If you have ordered additional memory for your Model 281xSA hub, it is a
good idea to install the new SIMM before you proceed with the hub
installation. You can upgrade the memory on the Model 281xSA hub at any
time, but you must open the hub cabinet to gain access to the SIMM socket.
For instructions on installing SIMMs, see Appendix I, "Replacing SIMMs."
Before you begin installing the Model 281xSA hub, prepare the installation
site. Evaluate the operating environment and make sure the location meets the
physical requirements of the chassis.
2-1