Marantz PM-11S3 Owner's Manual page 18

n How to set ID number for F.C.B.S.
When the unit is turned on, the display shows the ID number for three seconds.
For a master unit, ID number 1 needs to be assigned.
For a slave unit, set any of ID numbers 2 to 4.
INPUT SELECTOR
DISPLAY
TONE
SPEAKERS
A
INPUT
SELECTOR
SPEAKERS
B
DISPLAY
INTEGRARED AMPLIFIER PM-11S3
ATT.
PRE OUT
STANDBY
P.DIRECT
IN
VOLUME
X ON/OFF
PHONES
PHONO
MC
X ON/OFF
1
DISPLAY
While holding on the unit, press
2
INPUT SELECTOR
Turn on the unit to select an ID number.
3
Turn the unit off.
4
Again turn the unit on.
The setting is saved.
The unit registered as a slave shows "SLAVE" on the display.
NOTE
If using this unit by itself as a stereo amplifier, set the ID number to "0" (Default setting is
"0").
If the ID number is set to a number other than "0", this unit cannot be used for standalone
operation.
ENGLISH
F.C.B.S. connection
X ON/OFF
.
15