Table of Contents
Advertisement
5.
Connect the wiring as per the wiring
diagram on the following page. Ensure
that
the
terminals
tightened and that no bare wire is
visible. Be aware that existing wiring
circuits
are
coloured, and that there may be other
wired connections present in the back
box. If in doubt, always seek the advise
of a qualified electrician.
6.
Screw the socket to the back box and
ensure that the screws are su ciently
tight enough to support the product. Do
not over tighten as this may cause the
chassis to bend. Ensure that the plastic
spacer is correctly aligned and that no
wires are trapped between the socket
and the back box.
7.
Replace the plate – a 'click' sound
should be heard to signify that the plate
has been correctly replaced.
are
not
always
correctly
Installation
properly
Advertisement
Table of Contents
