Table of Contents
Advertisement
NOTE: Linking mode lasts for 12 seconds; if no signal is received from a
controller during this time then the socket will automatically exit linking
mode without linking the device.
If, when expecting a quick flashing blue LED to confirm pairing, a slow
amber flash is received instead, then the socket memory is FULL and no
further remotes may be linked with it unless one of the existing remotes is
unpaired first (see below).
Unlinking controllers and clearing the Socket memory
Removing a single device:
1. On the socket, press and hold down the
'on/o ' button until the blue and amber
LEDs flash alternately, and then release it.
That socket is now in linking mode.
2.
Using
a
Smartphone or Web App, press the button
intended to be unlinked; the amber light
on the socket will flash to confirm that the
App/controller is now unlinked.
LightwaveRF
Device Setup
controller,
Advertisement
Table of Contents
