Page 1
LightwaveRF connect Basic Adapter On/O Socket Operation Manual Model No: JSJS LW380 It is important to install this product in accordance with the tting instructions below. Failure to do so may render your guarantee void. IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND FOR GUIDANCE ON THE ASSOCIATION OF REMOTE HANDSETS.
Page 2
SETUP Pairing using LEARNING MODE: 1.Ensure the adaptor is plugged in and ready with the wall socket turned on.
Page 3
2. Once plugged into the wall the adaptor will enter LEARNING MODE for a duration of 5 seconds, this will be illustrated by the red LED ashing on and o . 3. Whilst the adaptor is in learning mode, press the desired ‘ON’...
Page 4
NOTE: Learning Mode lasts for only 5 seconds; if no signal is received from a remote handset during this time then the adapter will automatically exit learning mode without pairing the device. Unpairing Remotes and clearing the Switch memory Removing single device: 1.
Page 5
OPERATION Switch ‘ON/OFF’ with Remote Handset Press ‘ON’ on the handset to turn on adaptor(s) paired to the selected channel. Press ‘OFF’ on the handset to turn o adaptor(s) paired to the selected channel. NOTE: One channel can be programmed to turn on more than one socket with a single key press to create a group.
Page 6
Changing the Remote Battery 1. Pull out the battery holder. 2. Remove old battery and replace with a fresh one. 3. Replace battery holder into transmitter NOTE: • Connect correctly and securely • Do not recharge • Keep away from children •...
Need help?
Do you have a question about the JSJS LW380 and is the answer not in the manual?
Questions and answers