Table of Contents
Advertisement
d.
Optical drive
e.
Top cover (see
Remove the power button board:
1.
Position the top cover upside-down.
2.
Remove the Phillips PM2.0×3.0 screw (1) that secures the power button board to the top cover.
3.
Slide the board upward to disengage it from the tabs (2).
4.
Lift the board up to remove it from the top cover (3), while guiding the cable through the hole in the top
cover (4).
Reverse this procedure to install the power button board.
66
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Optical drive on page
49)
Top cover on page
58)
Hide quick links:
Advertisement
Table of Contents
